Working with one cabinet at a time, draw a sketch of that cabinet in the grid space on the center of the form.  To keep things organized, label the cabinet openings on your drawing and on the form below. Use capital letters for the doors and lower case letters for the drawers. 

If you are ordering hinges with your doors you will need to follow these instructions.  Measure the openings of the cabinet and list them on your drawing. 

Then, for all single doors and drawers add 1” to the width and height and write these sizes in the corresponding location on the form below, this will be the door and drawer front size you will be ordering.  Example drawer location ( a )  Width 12 + 1 = 13 Height    4 1/2 + 1 = 5 1/2

The cabinet opening that we highlighted here (location B), will need a set of pair doors (2 doors in the same opening) Round all pair door openings to the nearest 1/8th of an inch or greater, add 1” to the opening width then divide by 2, this will give you the width of each door. Make sure you add the 1” before you divide. To figure the heights just add 1” to the opening height.  Example: W= 26 7/8 + 1 = 27 7/8 ÷ 2 = 13 15/16 width of each door.  H = 20 1/8 + 1 = 21 1/8 height of each door. Make sure in the Qty column below you list 2 doors.

In the Hinges column, enter yes for hinges. The Hinge Side is for the side the hinges will be on. This will determine the direction the door will open. When you are ordering doors with hinges you will have four options Right, Left, Pair and Blank for no hinges. Indicate hinge side for single arch doors only.